Black Cartridges
1. Using the Thumb Drill included enlarge the filling hole
on the top of the cartridge. (Do not remove the cap).
2. Fill the syringe with ink, insert the filling needle into the filling hole and push as
far down into the cartridge as it will go. Inject approximately 15cc. of ink s-l-o-w-l-y
or until the reservoir is full.
3. Set above a paper towel for half an hour as
a drip precaution. Expect a few drips. Do not allow the cartridge to touch the paper towel
at this point, since the towel will draw out the ink.
4. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm
for Black
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. (Allows ink to flow to the
print head).
Note: Immediately refill any empty cartridges.
|